AirLink Communications RJ-11 Manuel d'utilisateur télécharger pdf (Page 8)

AirLink Communications March 2007 8

Connecting to a RADES Over Cellular Networks with AirLink Devices

For more information on the serial and other settings, refer to the RJ-11 IP Gateway User Guide.

FIGURE 10. RJ-11 IP Gateway: Reset/Reboot

Click the Reboot button to restart the RJ-11 IP Gateway with the configured settings.

Configuring the RADES to work with the RJ-11 IP Gateway

This basic configuration will enable you to get your RADES working with the RJ-11 IP Gateway

quickly.

Default Settings

• Mangement Interface IP Address: 192.168.1.1

• Web Interface Username: Admin

• Password: ZYPCOM

Configuring the RADES

You will need to enable routing capabilities in the RADES so that any packet received by the

RADES that doesn’t belong on its local network will be routed out via the phone line to the RJ-11

IP Gateway which will then send the packet to the Raven X which will send it on via the Internet to

its destination.

To configure the RADES, you will need to access its internal web-based interface.

A. Open the properties for your network connection. Start>Control Panel>Network Connections,

right-click on your local area connection, and select Properties.

Click on the Reset/Reboot menu option for the IP Address configuration and any changes to the

serial port settings to take effect.

Temporarily change the IP address on your computer to configure the RADES.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

AirLink Communications RJ-11 Manuel d'utilisateur Page 8