AirLink Communications Raven X HSDPA Guide de l'utilisateur télécharger pdf (Page 43)

Raven X HSDPA for Cingular - User Guide, version 2.33 38

AT Commands

FIGURE 8. HyperTerminal: Connection Name

2. Select COM1 (or the comport to which the modem is connected) for the Connect Using.

FIGURE 9. HyperTerminal: Comport Setting

3. Change the Bits per Second to 115200 (default), Data Bits to 8, Parity to None, Stop Bits to

1, and Flow Control to Hardware.

FIGURE 10. HyperTerminal: Comport Settings

4. Type AT and press Enter. You should get a reply of “OK” or “0”. .

5. To see what you are typing as you type it, you will need to turn on the echo and verbose mode.

Type ATE1V1 and press Enter.

If you get a reply of “OK”, then you entered the command successfully. If you get a reply of “0” or

“ERROR”, try entering the command again.

Using AT Commands with a Terminal Application

• The following pages list the AT commands, their parameters, and explain what they do. For

most commands, when you are entering them using a terminal connection, you will need to

preface the command with AT (exceptions are noted), i.e. ATA which listed as A

• Some commands have specific parameters while other commands will take whatever you type.

• Acceptable parameters and/or specific formats are in the parameters column.

Note: If you have configured the Raven X for settings different than the defaults

for Bits per Second, Data Bits, Parity, and/or Stop Bits, you will need to use your

changed settings.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 106 107

Pas de commentaire

AirLink Communications Raven X HSDPA Guide de l'utilisateur Page 43