AirLink Communications Raven X HSDPA Guide de l'utilisateur télécharger pdf (Page 89)

Raven X HSDPA for Cingular - User Guide, version 2.33 84

Simple Network Management Protocol (SNMP)

There are only three commands to set for SNMP in the Raven X: the listening port, the security

level, and the trap destination.

Listening Port

*SNMPPORT sets the port for the SNMP agent to listen on. If set to zero, default, SNMP is dis-

abled.

FIGURE 1. Wireless Ace: *SNMPPORT

Security Level

*SNMPSECLVL sets the security level and which version of SNMP communications are used.

FIGURE 2. Wireless Ace: *SNMPSECLVL

0 - No security required. SNMPv2c and SMNPv3 communications are allowed.

1 - Authentication required. SNMPv3 is required to do authentication and SNMPv2c transmis-

sions will be silently discarded. Authentication is equivalent to the authNoPriv setting in

SNMPv3.

2 - Authentication required and messages are encrypted. SNMPv3 is required to do authentica-

tion. SNMPv2c and SNMPv3 authNoPriv transmissions will be silently discarded. Authentica-

tion and encryption is equivalent to the authPriv setting in SNMPv3.

User Name and Password

The user name is 'user'. The user name cannot be changed. The Raven X's password is used as the

SNMP password (default is '12345').

To change the password in the Raven X, select Modem from the top menu line in Wireless Ace.

Note: SNMP generally uses port 161, however most Internet providers (including

cellular) block all ports below 1024 as a security measure. You should be able to

use a higher numbered port such as 10161.

Note: The eight-character password requirement for SMNPv3 is not enforced by

the

Raven X's Agent to allow the default password to function. Your SNMP

administrator or MIS may require you to change to a more secure and/or longer

password.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 106 107

Pas de commentaire

AirLink Communications Raven X HSDPA Guide de l'utilisateur Page 89