AirLink Communications Raven X HSDPA Guide de l'utilisateur télécharger pdf (Page 111)

Configuration Commands

Rev 2.0 Jul.09 104

• n=1:PrivateIPMode:WhentheHostinitiatesa1x

connection,thehostwillbegiventheIPaddressspecified

in*HOSTPRIVIP.Themodemwillthenperform1to1

NAT‐likeaddresstranslation,whichshieldstheHostfrom

networkIPchanges.

*HOSTPW=string

HostPasswordforPAP ,orCHAP,orPPPoE.

• string=password

*HOSTUID=string

HostUserIDforPAP ,orCHAP,orPPPoE.

• string=userid(upto64bytes)

PassThru

PassThruModeisusedtocommunicatedirectlytotheRaven

XEinternalhardware.

Caution: While the modem is in PassThru mode, ALEOS is disabled.

If you need to connect to the Raven XE while it is in PassThru mode,

you will need to do so with a terminal application. Not all commands

are available while the modem is in PassThru mode.

Figure 1-7: AceManager : PassThru

\APASSTHRU

Note: This mode is not available

through the remote AT telnet

server. You will need to connect

to the Raven XE with it

connected directly to your

computer.

Setsthemodemoperationtopassthroughmode.Thismode

willpassanycharactersreceivedontheportEthernetdirectly

totheinternalhardwaremoduleandoutputanycharacters

fromtheinternalhardwaremoduleouttheportEthernet.This

allowsdirectaccess/configurationofthehardwaremodule.

Oncethismodeisentered,

theunitmustbephysicallyresetto

returntonormaloperation.Thiscommandisnotavailablein

AceManager.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 124 125

Pas de commentaire

AirLink Communications Raven X HSDPA Guide de l'utilisateur Page 111