AirLink Communications Raven X HSDPA Guide de l'utilisateur télécharger pdf (Page 29)

Hardware Installation of the Raven XE

Rev 2.0 Jul.09 22

• Activity‐Lightswillflashasdataistransferredtoand

fromthePinPointmodemontheremotenetwork.

• Power‐Indicatesthepoweradapterisconnectedand

thereispowergettingtotheRavenXE.

• TheResetbutton(ontheleftsideoftheRavenXE)hastwo

functions.Ifitisquicklydepressedandreleased,the

modemwillsimplypowercycletheinternalhardware.If,

however, theresetisdepressedandheldforseveral

seconds(countapproximately30seconds,andwaitforthe

power

lighttogooffafterthelightpatternstops),the

ALEOSconfigurationsettingswillreturntothefactory

defaults.

Light Patterns

TheLEDsonthefrontofthemodemwillrespondindifferent

patternstoindicatemodemstates.

• Normal‐EachLED,mentionedabove,islitasapplicable.

• Startup‐TheLEDswillcyclefromlefttoright.

• ConfigurationReset‐TheLEDswillcyclelefttorightand

thenrighttoleft4times.

• AuthenticationFailure‐TheNetwork,Signal,and

ActivityLEDsblinkevery2seconds.

• DataRetry‐TheNetwork,Signal,andActi vityLEDsblink

every3seconds.

RSSI LED Ranges

RSSI/Signal LED Status Ranges of RSSI (dBm)

On Solid Equal to or stronger than -69

Fast Blink -70 to -79

Normal blink -80 to -89

Slow Blink -90 to -99

Extinguished Equal to or weaker than -100

Caution: If you reset the modem configuration using the reset button,

you may to reconfigure your APN.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 124 125

Pas de commentaire

AirLink Communications Raven X HSDPA Guide de l'utilisateur Page 29